Sensor Removable LED Floodlight

 Tip: Click on image to enlarge

Product Description :

 

1. SMD 28325 light source , high quality chip, high efficiency, high color rendering index;

2. High efficiency & energy saving. Under the condition of the same illumination,, it saves more than 70% energy compared with the traditional lamp.

3. No UV & IR . It wont distribute ray radiation

4. High-performance built-in constant current drive powerno stroboscopic, good for eyesight protection;

5. Thermal design, integration of the advanced die-casting forming, small contact resistance, high cooling efficiency



 Light-control sensor :

The product can turn on or turn off light automatically according to ambient-light. Ambient temperature and humidity can’t affect it. It is not only convenient but also practical; it can control the load working only at night. It is used for road light, garden light etc.


Technical  Parameters :

Model

BQ-FLBH100-10/20/30/50/80W-SMD

Material

Aluminum Alloy

Power(W)

10/20/30/50/80W

Input Voltage(V)

AC100-240V

Efficiency

88%

Power Factor

PF>0.9

Luminous Efficiency(lm/w)

90lm/w

CRI

Ra>80

Color Temperature(K)

2700-6500K

Beam Angle(°)

120°

Working Temperature(℃)

-20℃—+45℃

Lamp Color

Black/Grey

IP Grade

IP65

Lifespan(h)

35000H


Light Sensor :

SPECIFICATION:

Power source: 220-240V/AC                  Power Frequency: 50/60Hz                                 

Rated Current: 10A                                Ambient Light: <5-50 LUX (adjustable)

Working Temperature: -20~+40℃         Working Humidity: <93%RH 

                    


INSTALLATION : 

Ø Loosen two screws in the bottom and unload the black knob and plastic cover.

Ø Pass the wire through the black knob and plastic cover and connect the wire as per the Connection-wire diagram. And then install back the black knob and plastic cover.                 FIGUER    INCORRECT  CORRECT

Ø Please install the photocell in the correct orientation with the plastic bracket and according to the correct installation place, install the photocell with the enclosed inflated screws. (See the figure on the right).


CONNECTION-WIRE DIAGRAM:      

     

TEST: 

Ø Slide the LUX knob to position (-) and switch on the power.

Ø When you test in daytime. You should cover a black opaque cloth on the product.

Ø When the cloth mantles the detection window of the photocell, the ambient light of the photocell is less than 5 LUX, the lamp will be on.

Ø When you take off this cloth, the lamp will be off automatically.

Ø When you slide the LUX knob to position (+), the lamp could be on in the ambient light less than 50LUX.


NOTE:

Ø In front of the photocell, it should be no obstruction affecting to accept natural light;

Ø In front of the photocell, it should be no swaying object.

Ø Don’t install the photocell under the light or in the place where the light will be irradiated to the photocell.